Tighten Garage Door Spring

Side mounted springs are long heavy springs mounted on each side of the upper garage door track.

Tighten garage door spring. How to safely adjust your garage door spring. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller. Put on eye. This tension makes it easier to lift the garage door from its closed position.

If it was opening too quickly move it to the next lower hole. Next get hold of one of the tension rods and push it into the first notch. Through the use of pulleys they perform the same function as the torsion springs. Release your hold on the door and see if it stays up all the way.

Turn the rods to the right. It should be placed on the left hand side of the torsion spring and placed away from the garage door s center. Retest the door balance as you did in step 1. Once the screws are loosened place the second metal rod into an opposite notch on the cone and turn both rods to the right or to the left depending on whether you are tightening or loosening the tension.

Disconnect the garage door opener so the door remains closed. The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel. Step 1 unplug the garage door opener and clamp the door to the track. Adjust the springs on both sides of the door the same way.

They come under tension when the garage door is closed to make lifting the. Hold the garage door and remove the vise grips from the track after the spring tension has been adjusted. Locate a reddish color cone around the spring. Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.

Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar. This can make the other parts of the garage door last a much longer time. Slowly close your door about halfway and release it. Ideally the door should slowly float up from this point.

If the garage door easily swings open and closed then it will need to be tightened. Take note of the notches and screws that hold the torsion spring in place.